Get the battery-release latch and press down upon it with one hand, and then pull the battery away from the case, setting the pc battery aside.
The convenience furnished by the portability of a computer can
become a hindrance as a consequence of screen malfunctions? it will not be easy to
connect a new monitor and often with a desktop strategy. If the backlight
of your LCD screen has was unable, you can see any specific image. To fix this
problem, the entire inverter board and your connected LCD cable needs
to be manually changed. Here below are the instruction for your personal
reference.
1. Check on the manual of your laptop or search the infomation with
the Internet to support the component of the manufacturer抯 websites. Just simply
get that what mannequin fo inverter board you require for your computer, bring
my Pavilion DV2000 Show as instance, I get hold of a right one from an experienced site, HooToo. com, and after that i fix it on my own.
2. Turn off the actual laptop抯 operation system. Banned the LCD screen
sport bike helmet. CTurn the whole laptop over in order that the bottom end of the way it is is facing
up regarding you. Locate the battery-release latch and press down upon it
with one hand, and then pull the battery away from the case, setting the pc battery aside.
3. Locate the rubber pieces relating to the edges and the top of LCD. Pop the
stopper pieces off the case by inserting a designated object underneath
them and after that pulling out toward one. Use a screwdriver to withdraw the
screws hidden within the stoppers.
4. Put the computer back over and open the LCD screen online backup.
Slide a flat as well as thin object, such for a screwdriver, directly
underneath the seam for the plastic bezel underneath the LCD screen.
Wiggle the screwdriver vertical gently until the bezel pops heli-copter flight
case. Lift the bezel up and confirm if there is some cable running to
a motherboard. Disconnect the cable should there be one.
5. Pull so on the screen in your direction, and then remove the software from
the laptop. Locate the inverter board towards the bottom of the screen and additionally
find the cable running from inverter board to a motherboard. Pull
off the strip of tape relating to the board and remove any screws holding it during
place if there are any upon your particular model of computer. Disconnect
the cable with the motherboard.
6. Connect all the motherboard cable for plastic material bezel and place the bezel
back onto a laptop case. Finally, just put the battery on the laptop
and power them on, and then the moment the manufacturer抯 logo appear to the
screen, it mean you're successfull to install the fresh inverter
board and cord rightly.
Article Tags:
Inverter Plank
